HP Sticky Heatshield
- Capable of reflecting over 90% of radiant heat
- Flexible, bends and moulds to almost any shape
- Perfect for Jeeps, Broncos, or other 4 X 4 vehicles
- Adhesive backing sticks to almost any clean surface
- Can be cleaned after installed
- Made in the USA
HP Sticky Shield™ is the ultimate way to stop heat from radiating into the driver’s compartment of your ride. Made from a dense layer of 1/8" (3.2mm) thick proprietary Kool Core™ insulation and shielded by a rugged layer of 0.003" (0.08mm) thick aluminium, HP Sticky Shield™ may be cleaned after installation and is resistant to the elements. The heavy-duty peel-and stick adhesive backed heat barrier will bond to almost any clean surface, although it is not recommended for unfinished fiberglass or carbon fibre. It is the perfect radiant heatshield for transmission tunnels, mufflers, catalytic converters, DPFs, turbos, downpipes and exhaust systems.
HP Sticky Shield™ can be used with less than 1" (2.54cm) of airspace. However, when used with 1" (2.54cm) or more of airspace, this peel and stick heat shield is capable of shielding over 90% of heat. Did that set of long-tube headers on your Mustang, Camaro, Challenger or tuner move your catalytic converter to where there are no factory heatshields? Use self-stick insulation to stop the heat. That Jeep getting some serious heat in the transmission tunnel or from the cat? HP Sticky Shield™ it away.
HP Sticky Shield™ is asbestos-free and designed to be used under the vehicle on the floorplan, firewall, transmission tunnel and more. This sticky heat shield is not designed to be used underneath the carpet. Use Heatshield Armor Tape™ to seal seams when putting two of these heatshields together, and also to protect the edges of HP Sticky Shield™. You can even use the tape to repair any damage caused to HP Sticky Shield™ from on- or off-road hazards.
Our range of Heatshield Products Sticky Shield™ is available for next day delivery across the UK, subject to stock. See our delivery terms for more details.
- Insulation type: Heat shield barrier, designed to shield radiant heat away
- Not to be used directly on heat source.
- Base material(s): Fiberglass and aluminium