Cool Foil Tape
Continuous operating reflective temperature of 538°C
Capable of reducing up to 80% of radiant heat
Adhesive backing sticks to almost any clean surface
Helps shield fuel lines, brake lines, wire looms, and more from radiant heat
Bulk rolls and custom widths available, minimums apply
Made in the USA
Cuts easily with heavy scissors or utility knife
Cool Foil Tape is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source
Panel or component surface temperature should be at least 18°C, sticking onto anything colder may not allow adhesive to set up properly.
Degrease and clean surface any residual dirt, grease, or chemicals, use carburettor spray or other cleaner/degreaser.
We strongly recommend rubbing the surface with a pre-paint cleaner or isopropyl alcohol (or other non-residue cleaner) after cleaning and degreasing.
Carefully peel the adhesive backing off the Cool Foil Tape stick and go!